Gastroback 40126 Design Juicer Pro - Manual (Page 16)

wARNING: Always ensure that the juicer is switched off at the power outlet. then remove
the plug from the power outlet before cleaning, dissembling and storing the appliance. Do
not immerse the motor base in water or any other liquid. Do not use water jet to clean the
motor base. Do not clean the motor base in the dishwasher.
the centre of the filter basket and feed chute contain small sharp blades to process fruit
and vegetables during the juicing function. Do not touch blades when handling the filter
basket or feed chute.
ATTENTION: Abrasive and strong cleaner damage the surface of the plastic parts and
could cause discolouration. Never clean the appliance or parts with abrasive and strong
cleaner. For easier cleaning and to avoid discolouration: clean as you go and avoid dried
on juice or pulp residue. Immediately after each use, rinse removable parts in hot water to
remove wet pulp. otherwise discolouration of the plastic may occur with strongly coloured
fruit and vegetables. Allow parts to air dry.
Never use hard or sharp-edged objects when using or cleaning the juicer or the stainless
steel micro mesh filter. Do not use force when using the appliance to avoid damages.
Always assemble the appliance completely before storing. the parts are protected this way
and can not get lost.
ensure the juicer is correctly disassembled. Refer to ›Disassembling your Design Juicer Pro‹.
Follow these instructions to clean all surfaces of parts that come into contact with food dur-
ing normal use.
Filter bowl surround, juicer cover, stainless steel micro mesh filter, juice jug and pulp
container are dishwasher safe (top shelf only). use a program to be suited for glass (low
temperature). A program with high temperature might cause discolouration and distortion
of the plastic parts. Plastic parts might tarnish being frequently cleaned in the dishwasher.
ImPORTANT: Do not clean the food pusher in the dishwasher.
ImPORTANT: soak the stainless steel filter basket in hot soapy water for approximately
10 minutes immediately after juicing is completed. If pulp dehumidifies on the micro mesh
filter it may clog the fine pores of the micro mesh filter thereby lessening the effectiveness
of the juicer.
using the cleaning brush, hold the filter basket under run-
ning water and brush from the inside of the basket to the
outer rim. Avoid touching the small sharp blades in the
centre of the filter basket. After cleaning the filter basket,
hold it up towards a light to ensure the fine mesh holes are
not blocked. If the holes are blocked, soak the filter basket
in hot water with 10% lemon juice to loosen the blocked
holes. Alternatively, wash the filter basket in the dishwasher.
NOTE: Alternatively you can soak the filter basket in hot
water with dental prosthesis detergent. Rinse thoroughly
with clear water and the provided nylon brush.
ImPORTANT: Do not soak the stainless steel filter basket in
bleach. Always treat the filter basket with care as it can be easily damaged.
Wipe the motor base with a damp cloth. ensure of no water intrusion into the inside of the motor block.
CARE AND ClEANING
48