ETS-Lindgren 95242-1 Injection Probes - Manual (Page 25)

6.0 Insertion Loss
Insertion loss of the Bulk Current Injection Probe (BCIP) may be measured at low
signal levels. ETS-Lindgren offers this measurement as a calibration service. See
the Product Information Bulletin included with your shipment for information on
ETS-Lindgren calibration services.
Equipment
Signal Generator (50 Ohms): 10 kHz to 400 MHz
RF Voltmeter (50 Ohms): 10 kHz to 400 MHz
Calibration Jig: 95241-1
50 Ohm Termination: VSWR <1.2
Bulk Injection Current Probe: 95236-1 or 95242-1
Typical Reference Calibration Setup
Insertion Loss | 25