ETS-Lindgren 2005 Single Axis Positioner - Manual (Page 23)

Assembly and Installation | 23
Filter Installation
The filter is equipped with a 1 in. inside / 1.3 in. outside diameter (2.5cm
inside/3.3cm outside) standard pipe penetration conduit kit. This includes pipe,
conduit nut, brass nut, washer, circular EMI gasket and plastic cap. A 1.35 in.
(3.429cm) hole must be made in the shield of the room in order to accommodate
the conduit penetration of the filter. Drawings are included for reference during
installation.
• Open the gasketed compartment of the filter, being careful not to
damage the EMI gasket that sits below the cover.
• Remove the plastic cap, brass nut and washer from the conduit
penetration on the outside of the filter.
• Clean the shield using a scouring pad (provided by the customer)
suitable for cleaning stainless steel surfaces ensuring no glue residue
is present.
Failure to use an appropriate scouring pad to
remove all residue could result in reduction of
shielding effectiveness.