ETS-Lindgren 2005 Single Axis Positioner - Manual (Page 22)

22 | Assembly and Installation
Electrical Installation
Electrical connection should only be performed by
a qualified electrician and subject to location
electrical codes.
The Model 2005 Azimuth Positioner (AP) is designed to operate using 110/220
VAC single phase 50 or 60 Hz power. The branch circuit supplying power to the
motor base must be protected from excess current according to local electrical
codes. ETS-Lindgren has provided integral circuit protection in the motor base
assembly.
Check that the conductor size is adequate for the motor load and the distance
from the mains source is appropriate. Improperly sized conductors will lead to a
high voltage drop in the power conductors and cause reduced starting torque and
premature motor failure.
Prior to servicing the AP or the turntable motor
base, remove the power connection.
Connect the serial control cable and install the power connection per local
electrical code.