Dave Smith Instruments PROPHET 12 KEYBOARD - Manual (Page 20)

10 Global Settings Dave Smith Instruments
For example, the Resonance parameter has a value range of 0 to 127.
Let’s say the physical position of the Resonance pot is the equivalent of
a value of 100. If you switch to a program that has a stored Resonance
setting of 63 and turn the pot all the way up, it will only go to 90. To get
to the maximum value of 127, you first have to turn down until the value
is at the other extreme and the pot is at the limit of its travel (in this case,
0 and fully counter-clockwise, respectively).
In Passthru mode, turning the pot has no effect until after the edited value
equals the preset value (that is, until the edited value “passes through”
the stored value).
Jump mode uses an absolute value based upon the position of the pot
when edited: turn a pot and the value jumps immediately from the stored
value to the edited value.
14 . Sustain Footswitch: Normally Open, Normally Closed— There are
two types of momentary footswitches, normally open and normally
closed. Either type can be used with the Prophet 12’s Sustain switch
input. Not sure which type you have? If the footswitch’s behavior is the
opposite of what’s expected—that is, down is off and up is on—changing
this setting will correct that.
16 . Sustain Pedal Function: Sustain, Arp On/Off— The footswitch can
be used for sustain or to turn arpeggiator hold on and off.
15 . Pedal 1 Function: Breath Control, Foot Controller, Expression,
Master Volume, Lowpass Filter: Full Range, Lowpass Filter: Half
Range— Sets the function/destination for the Pedal 1 input. An expres-
sion pedal can be routed to any destination using the modulation matrix.
See Modulation on page 32 for more information.
16 . Pedal 2 Function: Breath Control, Foot Controller, Expression,
Master Volume, Lowpass Filter: Full Range, Lowpass Filter: Half
Range— Sets the function/destination for the Pedal 2 input. . An expres-
sion pedal can be routed to any destination using the modulation matrix.
See Modulation on page 32 for more information.
17 . Aftertouch Enable: Off, On— When on, the Prophet 12 will receive
and transmit aftertouch data via MIDI.