Coral Industries Quest Bypass (3/8 Frameless) - 2QG1-GP - Manual (Page 6)

2QG1-GP 10/08
Using glass as a template, hold top channel/roller fin
(D) behind glass, aligning top of glass with top of inside
surface of channel. Mark top channel through holes in
glass and drill using 1/8" drill bit.
Insert vinyl bushing into hole in glass. Position top
channel/roller fin over glass and secure using post and
screw provided.
Screw
D
Top Channel/
Roller Fin
Seal unit by caulking along outside of enclosure where
metal and bath meet, especially where sill and tub
meet. If desired, caulk inside of enclosure where jambs
meet walls.
Mount rollers (E) to top channel of doors using roller
washers (N) and roller screws (F). Rollers are to be
mounted on same side of doors as towel bars and at
the midpoint of slots.
Lift door panel into header with towel bar facing inside of
bath. Seat rollers on roller track while guiding bottom of
door into sill guide.
Repeat for remaining door, hanging panel with towel bar
facing outside of bath.
Adjust rollers up or down as needed in roller fin slots to
compensate for out-of-plump conditions, allowing
panels to hang straight.
Roller Screw
Roller
If top channel/roller fin is pre-installed on your unit,
proceed to Step 7.
Header
Inside
Panel
Inside
Panel
Outside
Panel
E
OUTSIDE
OF BATH
C
Header
C
Sill
Guide
A
G
F
6 Top Channel
(D)
7 Rollers
(E)
8 Hanging Door Panel
9 Caulking
Caulk outside of
enclosure where metal
and shower meet.
Post
Bushing
Roller Washer
N