Coral Industries Quest Bypass (3/8 Frameless) - 2QG1-GP - Manual (Page 5)

2QG1-GP 10/08
Remove jambs from tub and drill where marked using
1/8" drill bit.
Reposition jambs on tub and mount to wall using
8A x 1 1/4" pan head screws (K). Mount bumpers (J)
horizontally in top and bottom holes.
Measure from wall to wall (over the top of both jambs)
and cut header (C) to that measurement.
Lower header over jambs until seated squarely on legs
of both jambs.
Secure header to jambs by drilling a 1/8" hole through
header into jambs on inside of bath near walls. Attach
header to jambs using 8A x 3/8" truss head screws
(L).
Jamb
Header
B
C
8A x 3/8" Truss
Head Screw
L
INSIDE OF BATH
3 Jamb
(B)
4 Header
(C)
Towel bars from towel bar kit (H) are to be mounted
onto door panel through predrilled holes in glass.
Towel bar for outside panel faces outside of bath while
bar for inside panel faces inside of bath.
Towel bar kit comes with parts assembled in the order
they will be installed on glass. Disassemble parts.
Press bushings into holes in glass. Trim as needed so
that bushings are flush with surface of the glass.
Reassemble towel bar, plastic washers, and end cap
on door panel as shown. Allen wrench may be used to
aid in tightening by inserting into hole of end cap and
turning. Repeat for remaining door panel.
Towel bar for outside panel faces
outside of bath while bar for inside
panel faces inside of bath.
OUTSIDE OF BATH
Towel Bar
Plastic
Washer Bushing
Plastic
Washer
End
Cap
5 Towel Bars
(H)
8A x 1 1/4" Pan
Head Screw
Bumper
Jamb
Jamb
B
B
K
Sill
A
J
Measure
Jamb
B Jamb
B
Sill
A
OUTSIDE OF BATH
H