Coral Industries Regal Swing Door/ILP (1/4 Frameless) - 0FJ - Manual (Page 7)

0FJ-P 8/08
Working from outside of shower, drill through sill into
double channel. Secure using 8A x 3/8" truss head
screw.
In-Line
Panel
OUTSIDE OF SHOWER
8A x 3/8"
Truss Head
Screw
Double
Channel
Door
Magnetic
Door
Stop
9 Securing Verticals
K
10 Push / Pull Handle Kit
(P)
Handles will be mounted on glass before hanging door panel.
Push / Pull handle kit (P) comes with parts assembled in the
order they will be once installed on glass. Disassemble parts.
Place bushings in holes in glass. Trim as needed so that
bushings are flush with surface of glass. Place one plastic
washer on each connector screw and insert screws (from
inside surface of glass) through bushings in glass.
Place second plastic washer on exposed end of connector
screws on outside surface of glass. Holding exterior handle
in place on outside surface of glass, tighten connector screw
to secure handle.
On inside surface of glass, slip interior handle over connector
screws and tighten with 3/32" allen wrench.
Exterior
Handle
Plastic
Washer
Handle
Connector
Screw
Bushing
Plastic
Washer
INSIDE OF SHOWER
3/32 Allen
Wrench
Interior
Handle
Push/Pull Handle Kit P
Measure width of door glass at bottom. Trim vinyl drip
sweep (F) to door glass width minus 1/8”. Trim only
from hinge end of drip sweep. Contour cut end of drip
sweep fin to remove sharp point.
Press drip sweep onto bottom edge of door glass with
fin facing inside of shower and edge of drip sweep flush
with edge of glass on hinge side of door. (Drip sweep
will be 1/8” from edge of glass on opening side of door.)
F Vinyl Drip
Sweep Fin faces inside
of shower.
OUTSIDE OF
SHOWER
11 Vinyl Drip Sweep
(F)
Drip Sweep length =
Door Width minus 1/8”