Code 3 WingMan with TriCore for Crown Victoria - Manual (Page 7)

7
Wiring Diagram - WITH ARROWSTIK
®
GREEN (PATTERN SELECT)
WHITE (DIMMING)
RED (POWER)
YELLOW (RIGHT ARROW)
ORANGE (LEFT ARROW)
BLUE (LEVEL 1)
BLACK (GND)
6 HEAD ARROWSTIK
®
W (2) OUTER LIGHT HDS FLASHING ALTERNATELY
The WingMan™ can be configured as a 6 or 8 head ArrowStik. To change the WingMan from an 8 head ArrowStik to a 6 Light
Head configuration with the (2) Outboard Light Heads flashing alternately, remove the mounting screws that attach the Wing-
Man's Cover to the Outer Panel to gain access to the printed circuit board inside (see the exploded view on page 9). Move the
Shunt Option Jumper (JP1) on the printed circuit board to the "OPTION JP1" position as shown below. When configured for a 6
head operation the (2) Outboard Light Heads will alternate during any ArrowStik mode. Carefully replace the WingMan's Cover
over the Outer Panel and replace the Cover Mounting Screws.
Note: Be extremely careful to replace the wiring such that you don't pinch a wire when you
replace the WingMan's Cover. Test the unit to be sure that it works properly.
<---------------"OPTION JP1" Jumper Position