Code 3 WingMan with TriCore for Crown Victoria - Manual (Page 5)

5
FIGURE 12
Step 10 Remove the two outer child restraint seat belt covers (see Figure 12). Note: The seat belt covers may be kept in place if
desired. The interfering portion of the covers must be trimmed to fit after the WingMan™ Rear Bar is installed.
Step 11 Twist the wires of the WingMan's cable and feed the WingMan's cable through the cable hole and into the trunk (see Figures
13 and 14).
FIGURE 13 FIGURE 14
FIGURE 15 FIGURE 16 FIGURE 17
FIGURE 18
FIGURE 19
Step 12 Install the rear WingMan Bar by positioning the bar in the center of the rear window centered on the brake light housing and
position over the mounting brackets (see Figure 15). You will have to continue feeding the cable through the hole simultaneously while
moving the bar into position.
Step 13 Align the mounting holes in the WingMan Bar with the mounting bracket and mounting plate holes and insert the supplied
1/4-20 x 1/2" bolts and internal tooth lock washers (see Figures 16 and17). Make sure the spacing around the rear brake light hous-
ing is the same all around and the perimeter shape of the mounting plates line up with the shape of the mounting brackets (it may
be necessary to slightly loosen the mounting bracket bolts in the trunk to center the light bar around the brake light housing). After
everything is centered and aligned, tighten the bolts with a phillips screwdriver (see Figure 18).
Step 14 Finish tightening the mounting bolts in the trunk (see Figure 19).
The bracket fasteners shown in Figures 16, 17, and 18 make excellent hard mounting
points for radar guns and video cameras, etc.
Caution: Drilling into the housing of the light bar could damage wiring or other internal
components.