Code 3 WingMan for Crown Victoria - Manual (Page 9)

9
LED Fusing Considerations
Although the average current draw per module is very low, due to the type of circuit used to power each module, the instantaneous
peak current to a module can be significantly higher during low voltage conditions. To avoid prematurely blowing ATO style fuses or
tripping breakers it is recommended the following rule-of-thumb be used to size fuses or breakers. This is especially important in light
bars with many LED modules running off a single fused source.
Minimum fuse size calculation:
For LED 12 volt electrical current
1.5 x (number of modules being fused)
Example:
2 intersection modules and 6 directional modules.
Minimum fuse requirement for single fuse - 1.5 (8) = 12 A
Product Features
LED lighthead options: Red, Blue, Amber; Directional or Spreading; Flashing or Steady-Burn Control
LED lightheads: LED-X, Optix, LCLED
Size: 46.346" long x 2.00" tall x 7.406" deep (LONG VERSION)
Size: 25.300" long x 2.00" tall x 6.125" deep (SHORT VERSION)
Weight: 7.5 lbs
NarrowStik Version
The WingMan can be factory configured as a traffic director and operated using a NarrowStik® Control Head. Please refer
to the NarrowStik Control Head Manual packaged with the control head for installation, wiring connections, and operation
of the Control Head.
This Product contains high intensity LED devices. To prevent eye damage,
DO NOT stare into light beam at close range.
!
WARNING!
Wiring
Refer to the NarrowStik wiring on page 10 for wire designations. For models with independently flashing red/blue heads
located on each end, the Blue and Brown wires will be used to control these heads. The Blue wire is connected to+12V and
the Brown to Ground. Refer to the Control Head manual for operation with the Control Head.