Code 3 WingMan for Crown Victoria - Manual (Page 3)

3
Mounting Hardware -
All mounting hardware is packed in a small box inside the main carton. There are two brackets
and two mounting plates used to mount the WingMan to the vehicle. These are discussed in detail later.
FIGURE 1
Installation Instructions
Note: The long version of the WingMan Rear Lightbar is illustrated in the following instructions but the steps are the same
for both long and short versions!
Step 1 Open the Crown Vic's trunk, move the spare tire from it's shelf to the bottom of the trunk, and place a piece of plywood or boards
over the spare tire well so that there is a flat level platform to work from (see Figure 1).
This will provide a more comfortable position for locating and drilling the mounting holes and the cable hole.
Step 2 Measure over 3 inches from the center of the brake light mounting stud towards the outside of the Crown Victoria and mark the spot.
This is the side to side location of the lightbar's mounting hole (shown in Figure 2). Measure 7/16"
from the inner bend of the sheet metal at
the level closest to the spot welded seam in the Crown Vic's trunk and mark the spot. This is the front to rear location of the mounting hole
(shown in Figure 3). Repeat the step for the mounting hole at the opposite side of the brake light. Note: The final distance between the two
mounting holes will be approximately 12 1/8". When the marks are in the correct location they will look as shown in Figure 2A for the
Passenger side and as shown in Figure 3A for the Driver's side.
FIGURE 2 FIGURE 3
Brake Light-
Mtg Stud .......
.......>
To
Front of vehicle ---------->
<-->
---7/16" from bend
in sheet metal
<---------------
------
<------------------> <------------
-----
3" from Brake-------
Light Mtg Stud
FIGURE 2A(PASSENGER SIDE) FIGURE 3A(DRIVER'S SIDE)