Light head preparation – Code 3 Universal Mirror User Manual

Page 4

Light head preparation:

1. Feed wires from light head through to inside of rubber cover (fig 4)

2. Terminate cable ends under pivot bracket on mirror assembly (fig 5) using either the male

or female quick slide connectors supplied.

3. Feed wires from light head through or over the pivot bracket and terminate light head

assembly under pivot bracket using quick slide connectors of the opposite type used on the

cable assemblysupplied in mounting kit.

4. Mate connectors such that Power is to the Red wire from the light head, Black to ground

and either Purple for syncronization, or White for pattern selection to the third wire provided.

(fig. 6)

4. Tuck wire connectors under mounting bracket assembly and proceed with cover

installation as shown. (fig 7)

5. Proceed with installation in Step 5- page 5 of installation manual.

fig 4

fig 5

fig 6

fig 7