Code 3 Universal Mirror - Manual (Page 2)

2
Step 1. Select mounting area
and drill 1/2" dia. cable hole
into center of area.
Align Horizontally on mirror
housing using level as shown.
Step 2. secure lower
mounting bracket to
mirror housing using (2)
star washers and self tap-
ing S.S. screws supplied
Step 3. Attach pivot bracket
to mounting bracket, making
sure to place star washer be-
tween bracket faces as shown.
(a small amount of adhesive can be
used to hold star washer in place if de-
sired during assembly)
(Do not tighten until step 4)
Step 4. Align Vertically
by placing level across
face of pivot bracket
as shown, then tighten
screws on ends of pivot
bracket
Vehicle must be parked on level surface during installation