Warning – Code 3 Stop/Turn/Tail User Manual
Page 3
3
3.
Cut the opening and drill the holes, use the template in Figure 2 or the trim bezel if your light head is so
equipped. (No opening necessary for 41SPKG.)
4.
With one end on the cable at the light head mounting location, route the wire cable back to the cab of the
vehicle or route to connect into the existing stop/tail, turn signal, and reverse light wire circuitry at the rear
of the vehicle.
5.
At the light head end of the cable, insert the AMP sockets into the AMP socket housing as shown in
Figure 3. Cut the shield wire flush with the jacket.
6.
Allow at least 3 inches of slack at the light head to facilitate lamp replacement.
7.
At the power source end of the cable determine if the cable length is acceptable. If a shorter length is
required, cut the cable to the proper length and strip back the outer jacket three inches.
This is a full size template.
Do not use a facsimile or
copied reproduction. Do
not use this template if the
largest dimension in each
direction is not within +/-.010.
WARNING!
!
FIGURE 2
RED WIRE - TAIL
BLACK WIRE - GROUND (EARTH)
WHITE WIRE - STOP, TURN, REVERSE
SHIELD WIRE (REMOVE)
THIS END TO POWER
SOURCE
FIGURE 3