Code 3 Stop/Turn/Tail - Manual (Page 2)

2
Introduction
The 41 Series Stop/Tail, Turn Signal, and Reverse Light Heads are designed to meet the requirements of
Federal Motor Vehicle Safety Standard No. 108.
The product is designed to be installed on the rear of the vehicle. The product group includes a stop/tail
light(red), a turn signal (amber) with directional arrow, and a reverse light(clear). The +12V system is to be
connected to the stop/tail, turn signal, and reverse light circuitry of the vehicle.
Unpacking And Pre-Installation
Carefully remove the light head from its protective packaging. Inspect the unit for transit damage( broken lamps,
scratched lenses, etc.). Report any damage to the carrier and keep the shipping carton.
Verify that there are four (4) #6 X 1-1/2” mounting screws included for each lighthead.
If the three wire cable package was also purchased, verify that each end is terminated with AMP #60619-1 pin
sockets and the parts bag contains two (2) AMP #1-480303-0 Mate-N-Lock socket housings and one #8
noninsulated ring terminal.
Installation And Wiring
Use the following task list as a guide for installing the 41 Series light heads .
1. Select the desired mounting location for the light head assembly.
2. Verify 2 inches of clearance exists behind the mounting surface, see Figure 1. (Not necessary for
41SPKG.)
EXTERIOR WALL OF VEHICLE
INTERIOR WALL OF VEHICLE OR NEAREST
OBSTACLE DIRECTLY BEHIND LIGHT HEAD
2" MINIMUM CLEARANCE
FIGURE 1
Read and follow the manufacturer’s instructions before installing or using this device. The
vehicle operator should insure daily that all features of the device operate correctly. In use,
the vehicle operator should insure the projection of the lights signal is not blocked by vehicle
components (i.e. open trunks or compartment doors), or other obstructions. Proper installation
is vital to the performance of this device and the safe operation of the vehicle.
WARNING!
!