Code 3 PSE475 Remote Strobe Power Supply - Manual (Page 6)

FLASH CONTROL HARNESS ASSEMBLY
The Flash Control wire harness is to be connected to the 4 position socket connector on the PSE475
strobe power supply (See Figure 3 on page 5). The Flash Control harness consists of an AMP 4 pin connector
with 4 wires : white, orange , yellow and brown (See Figure 5). These are activated by connecting to a source of
+Vdc (they are low current inputs).
This control harness is to be connected to a customer supplied control cable, which in turn is to be connected
to a customer supplied switch to complete the installation.
Refer to the Flash control options and Switching Control variations sections for details on Flash Control
connections.
THIS END TO POWER
SUPPLY
3. With the AMP 3 pin connectors terminated properly , plug each cable into the appropriate 3 position socket
on the PSE475 strobe power supply. The outlet chosen for each cable will be determined by the Flash pattern
selected. See Flash Control Switching Options Section for further details on flash selection.
POWER-INPUT WIRE HARNESS ASSEMBLY
The Power-input wire harness is to be connected to the 3 position socket connector on the PSE475 strobe
power supply. See Figure 3, page 5.
The Power harness assembly consists of red (+Vdc) and black (Ground/Earth) wires that power the
PSE475 strobe power supply and a green wire for Hi/Lo intensity control. Figure 4
The Hi/Lo intensity feature allow the strobe lights of the system to be switched into low power for night use
by connecting the green wire either to + Vdc or Ground (Earth). If this feature is not used it is important to
remove this wire.
Power-Input Harness Assembly
PSE PN 3557
FIGURE 4
BLACK WIRE (NEGATIVE)
Flash Control Harness Assembly
PSE PN 3556
FIGURE 5
THIS END TO POWER
SUPPLY
6
RED WIRE (POSITIVE)
GREEN WIRE (+/-)
ORANGE WIRE (+) POSITION 3
WHITE WIRE (+) POSITION 4
YELLOW WIRE (+) POSITION 2
BROWN WIRE (+) POSITION 1