Code 3 PSE475 Remote Strobe Power Supply - Manual (Page 5)

5
FIGURE 3
NOTE: USE AMP HAND TOOL PART NO. 90124-2 OR EQUIVALENT TO CRIMP SOCKET PINS TO THE
WIRES.
SHIELD WIRE
CONNECT TO CHASSIS
GROUND
2. After the cables have been properly installed and routed, the three wires will have to be inserted
into the AMP 3 pin socket housing before being plugged into the power supply.
NOTE: IT IS VERY IMPORTANT TO OBSERVE THE PIN LOCATIONS AND ORDER OF COLOR ON THE
AMP 3 PIN SOCKET HOUSING. IMPROPER CONNECTIONS COULD DAMAGE THE POWER SUPPLY
AND STROBE TUBE ASSEMBLIES. SEE FIGURE 2
RED WIRE - (ANODE) POSITION 1
BLACK WIRE - (CATHODE) POSITION 2
WHITE WIRE - (TRIGGER) POSITION 3
STRIP INSULATION TO EXPOSE
BARE WIRE AS SHOWN
THIS END TO POWER
SUPPLY
FIGURE 2
CRIMP TO INSULATION ONLY
CRIMP OVER BARE WIRE
1/8 INCH
AMP 3 PIN SOCKET HOUSING
PN 1-480303-0
AMP SOCKET PIN
PN 60619-9
15 AMP FUSE FOR STROBE
POWER SUPPLY PROTECTION
POWER INPUT HARNESS
FLASH CONTROL HARNESS
STROBE HEAD OUTLET #4
STROBE HEAD OUTLET #2
STROBE HEAD OUTLET #3
STROBE HEAD OUTLET #1