Code 3 MX 7000 - Manual (Page 13)

Multi-Functional Intersection Control System - This system allows multiple lighting options with a single
pair of intersection lights. The control center of the system is the Multi-Functional Control Module located in
the lower section of the light bar. This combined with the Sensing Lighthead Assemblies, located in the front
lower section, allows the operator to select (4) four modes of operation - intersection, driver side alley,
passenger side alley and takedown positions.
Figure 8
Sensing Lighthead Assembly - As with the standard
intersection lights, these are high intensity 120 degree
oscillating light assemblies. With addition of the Position
Sensing module these lights can be placed in the takedown or
alley positions.
Note: If the gear assembly is replaced, care must be taken to
insure that the flat nylon washer is seated between the gear
and the bottom plate to prevent premature wear and failure.
Multi-Functional Control Module -
Using standard lighting controls the operator
can select the operation of the Lighthead
assemblies.
Figure 10
S50690 - Driver side assembly
S50691 - Passenger side assembly
S55401 - Multi-Functional Control Module
* - see wire tag for
exact wire color code.
OSCILASER TM - This is a highly effective warning light that
features a constant 35 watt halogen signal that covers every area
within it's field of illumination at least once per second. It has an
up and down as well as a side to side signal. Maintenance for
these units is much the same as a typical rotator. The lamps used
are bayonet type. This unit is located in the upper center section
and/or in the center position in the outboard sections of the light
bar. See Figure 8.
Figure 9
Figure 11
Figure 12
Passenger’s Side Driver’s Side Control Module
Sensor Wiring Harness -
Red - Power
Blk - Ground
Grn - Alley
Yel - Takedown
13