Defender® - exploded view, Maintenance – Code 3 Defender User Manual
Page 9

9
FIgURE 7
DEFENDER® - EXPLODED VIEw
FIgURE 2
1
2
8
8
9
9
3
4
5
6
10
7
Maintenance
Lens Cleaning
Use plain water and a soft cloth, or Code 3® lens polish and a very soft paper towel or facial
tissue. Plastic scratches easily, as a result, cleaning is recommended only when necessary
(about every six months). Do not subject the lenses to car washes that use brushes, as these
will scratch the lenses.
Lens Removal
With a Phillips screwdriver, remove the (4) #8 X 5/8" Phillips Pan Head Hi-Lo Screws W Neo-
prene Washer (See Figure 2). Then gently lift the lens off. When finished carefully replace the
lens making sure the lens gasket is not misplaced, then replace the lens mounting screws mak-
ing sure the neoprene washers are in place.
Light head Removal
Unplug the TriCore® light head's power wire/wires from the light bar's wiring harness. Then with
a 1/4" Hex Bit Driver, remove the #8 X .270" 6 Lobe Hex Washer Head Screws that attach the
light head mounting brackets to the light bar. Note: For front or rear facing light heads there
are (2) screws holding each light head and for corner light heads there are (6) screws
holding the light head. Then remove the light head (See Figure 3).
FIgURE 3