Code 3 DeckBlaster - Manual (Page 7)

7
Unit does not flash. No power connected to unit. Connect unit to power.
Blown fuse. (External) Check user-installed fuse.
Replace with properly sized fuse.
Worn flashtube or halogen lamp. Replace flashtube or halogen lamp
with recommended replacement.
Circuit board failure. Replace circuit board assembly
Reversed polarity on power. or send unit in for service.
Unit flashes intermittently Loose connection in wiring. Check wiring for loose connection.
Flashtube installed incorrectly. Check flashtube for proper instal-
lation as illustrated in Fig. 6.
Worn flashtube or halogen lamp. Replace flashtube or halogen
lamp with recommended replace-
ment.
Light output appears dim. Dirty lens. Clean lens.
Voltage drop in wiring. Check power wire sizing. Replace
with larger wire to reduce voltage
drop.
Worn flashtube or halogen lamp Replace flashtube or halogen lamp
with recommended replacement.
Flashrate not correct Low input voltage. Check input voltage to unit and
make sure it is between 10 and
16 VDC.
PROBLEM PROBABLE CAUSE REMEDY
Troubleshooting
Deckblaster Parts List (Remote Model)Ref No. Description Part No.
Qty.
1 Upper Case Half T06570 1
2 Reflector Bracket S35321 1
3 Wiring - Straight Cord S35250 1
4 Reflector S81231 1
5 Flashtube S82108 1
6 Lens - Half w/Optics T0202X 2
- Half smooth T0204X 2
- Full w/Optics T0203X 1
- Full smooth T0206X 1
7 Lower Case Half T06571 1
8 Case Screws - #8x1/2", "B", Hex, Philips T00238 4
Not Shown Mounting bracket/Tether Cord Kit S65492 1
Rear-Deck Mounting Kit (Optional) RDMNT
Hook and Loop Mounting Kit (Optional) HLMNT
Suction-Cup Mounting Kit (Optional) SCMNT