Code 3 DeckBlaster - Manual (Page 2)

Introduction
The DeckBlaster ® product line represents the latest advances in low cost directional dash and deck-mount-
able warning lights. Designed for durability and high reliability, the Deckblaster’s low-profile design makes it
ideal for use in many applications. The line boasts five separate models, available in both strobe and halogen
configurations. These include a basic flashing halogen, a basic flashing strobe, a switchable halogen, a
steady burn halogen and a remote strobe.
Carefully remove the unit from the box, taking care not to scratch the lens, and examine it for any transit
damage. You may wish to test the unit for proper operation before installation. To test models with a cigarette
plug, firmly twist the plug on the unit into a +12 Volt D.C. cigarette lighter. For models without a plug, touch
the black wire to ground (earth) and the red wire to the +12 Volt D.C. A battery may be used for this purpose.
For the remote strobe, plug the connector into an appropriate CODE 3 strobe power supply. If the vehicle has
an electrical system other than +12 Volts D.C. negative ground (earth), contact your local representative or
call the Electronics Technical Assistance HOTLINE at (314)426-2700 Ext. 2131 for instructions.
NOTE: Flashing halogen and strobe units will require a filtered power supply for proper operation
without a battery.
Unpacking & Pre-installation
The use of this or any warning device does not insure that all drivers can or will observe or
react to an emergency warning signal. Never take the right-of-way for granted. It is your
responsibility to be sure you can proceed safely before entering an intersection, driving
against traffic, responding at a high rate of speed, or walking on or around traffic lanes.
The effectiveness of this warning device is highly dependent upon correct mounting and
wiring. Read and follow the manufacturer’s instructions before installing or using this
device. The vehicle operator should insure daily that all features of the device operate
correctly. In use, the vehicle operator should insure the projection of the warning signal is
not blocked by vehicle components (i.e.: open trunks or compartment doors), people,
vehicles, or other obstructions.
This equipment is intended for use by authorized personnel only. It is the user’s responsi-
bility to understand and obey all laws regarding emergency warning devices. The user
should check all applicable city, state and federal laws and regulations.
Public Safety Equipment, Inc., assumes no liability for any loss resulting from the use of
this warning device.
Proper installation is vital to the performance of this warning device and the safe operation
of the emergency vehicle. It is important to recognize that the operator of the emergency
vehicle is under psychological and physiological stress caused by the emergency situation.
The warning device should be installed in such a manner as to: A) Not reduce the output
performance of the system, B) Place the controls within convenient reach of the operator
so that he can operate the system without losing eye contact with the roadway.
Emergency warning devices often require high electrical voltages and/or currents. Properly
protect and use caution around live electrical connections. Grounding or shorting of
electrical connections can cause high current arcing, which can cause personal injury and/
or severe vehicle damage, including fire.
PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER
USE OF EMERGENCY WARNING DEVICES IS ESSENTIAL TO INSURE THE SAFETY
OF EMERGENCY PERSONNEL AND THE PUBLIC.
WARNING!
Installation & Mounting
ING!
!
!
WARNING!
2
This unit must be mounted within the interior passenger compartment of the vehicle only.
It is not intended for use in exterior applications.