Code 3 DeckBlaster - Manual (Page 6)

Halogen Lamp/Flashtube Replacement for non-remote models
Remove the circuit board/reflector assembly. Using a needle-nose pliers,
straighten the leads of the tube or halogen lamp protruding through the
circuit board on the component side of the board. Using hand protection,
grasp the lamp or tube gently and pull to remove from the reflector,
taking care not the break the glass. Replace with a CODE 3 approved
replacement as found in the parts list on page 7. When reinstalling
the halogen lamp, take care to note the lamp orientation as shown
on page 7. The red marking on the flashtube should be oriented
such that it is to the right side of the reflector when facing the unit in
it’s upright position, see Fig. 5. Incorrect installation could result in
premature failure of the flashtube or intermittent operation. Reassemble the
unit. Connect the unit to power to verify that it operates properly before reinstalling.
Heatsink Up
Red Dot
Fig. 5
Lamps are extremely hot! Allow to cool completely before attempting to remove. Gloves
and eye protection should be worn when handling halogen lamps as they are pressurized
and accidental breakage can result in flying glass.
Flashtube replacement for remote model
Disconnect the unit from the power supply and disassemble. Remove the bracket/reflector assembly from
the housing and unplug the power cable from the lamp. Using hand protection, grasp the lamp from the front
of the reflector and turn counterclockwise until it comes free. Pull the lamp forward through the reflector and
replace it with a CODE 3 approved replacement as found in the parts list on page 9. Reassemble the unit
by reversing the above steps.
!
WARNING!
1
6 4
5
2
3
7
8
6