Code 3 DashLaser - Manual (Page 9)

WARNINGS FOR LIGHTING PRODUCTS
INTRODUCTION
The use of this or any warning device does not insure that all drivers can or will observe or react to an emer-
gency warning signal. Never take the right-of-way for granted. It is your responsibility to be sure you can
proceed safely before entering an intersection, driving against traffic, responding at a high rate of speed, or
walking on or around traffic lanes.
The effectiveness of this warning device is highly dependent upon correct mounting and wiring. Read and
follow the manufacturer’s instructions before installing or using this device. The vehicle operator should insure
daily that all features of the device operate correctly. In use, the vehicle operator should insure the projection
of the warning signal is not blocked by vehicle components (i.e.: open trunks or compartment doors), people,
vehicles, or other obstructions.
This equipment is intended for use by authorized personnel only. It is the user’s responsibility to understand
and obey all laws regarding emergency warning devices. The user should check all applicable city, state and
federal laws and regulations.
Public Safety Equipment, Inc., assumes no liability for any loss resulting from the use of this warning device.
Proper installation is vital to the performance of this warning device and the safe operation of the emergency
vehicle. It is important to recognize that the operator of the emergency vehicle is under psychological and
physiological stress caused by the emergency situation. Warning devices should be installed in such a
manner as to: A) Not reduce the output performance of the system, B) Place the controls within convenient
reach of the operator so that he can operate the system without losing eye contact with the roadway.
Strobe power supply and flash tubes utilize high electrical voltages and/or currents. Properly protect and use
caution around live electrical connections. Grounding or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fire. Incandescent
lamps are extremely hot, allow to cool completely before attempting to remove.
Any electronic device may create or be affected by electromagnetic interference. After installation of any
electronic device operate all equipment simultaneously to insure that operation is free of interference. Never
power emergency warning equipment from the same circuit or share the same grounding circuit with radio
communication equipment.
PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER USE OF EMER-
GENCY WARNING DEVICES IS ESSENTIAL TO INSURE THE SAFETY OF EMERGENCY PERSONNEL
AND THE PUBLIC.
INSTALLATION AND MOUNTING
GENERAL
All devices should be mounted in accordance with the manufacturer's instructions and securely fastened to
vehicle elements of sufficient strength to withstand the forces applied to the device. Driver and/or passenger
air bags (SRS) will affect the way equipment should be mounted. This device should be mounted by perma-
nent installation and within the zones specified by the vehicle manufacturer, if any. Any device mounted in the
deployment area of an air bag will damage or reduce the effectiveness of the air bag and may damage or
dislodge the device. Installer must be sure that this device, its mounting hardware and electrical supply wiring
does not interfere with the air bag or the SRS wiring or sensors. Front or rear grille/bumper placement must
avoid interference with SRS sensors. Mounting the unit inside the vehicle by a method other than permanent
installation is not recommended as unit may become dislodged during swerving, sudden braking or collision.
Failure to follow instructions can result in personal injury.
MAGNETIC MOUNTING
1) Rust Stains: Magnetic mounting is not intended as permanent mounting for beacons. Long duration usage
of any magnet will expose the high iron content of the steel, thereby causing rust. The device should be
removed when not used to prevent rust stains. Metallic debris collected by the magnet will also contribute to
rust stains. Insure that the magnet is kept clean.
2) Surface rust stains can usually be removed with chrome polish, available at most auto part stores.
IMPORTANT:
!
9