Code 3 DashLaser - Manual (Page 11)

Troubleshooting
PROBLEM CAUSE REMEDY
Light is not lit and the reflector is No power at lighter plug Check ignition and fuse. Try
not turning another vehicle
Damaged or defective cordset Repair or return to P.S.E.
Reflector is turning but the light Lamp is burned out Replace lamp.
is not lit Missing or loose lamp clip Replace lamp clip
Defective wiring to the motor Repair or return to P.S.E.
The light is lit but reflector is not Rotating assembly is jammed Remove obstruction or return to
turning P.S.E.
Defective wiring to the motor Repair or return to P.S.E.
Defective motor Replace or return to P.S.E.
Light is not bright and reflector Low Voltage Try in another vehicle. Repair or
turns slow - less than 70 RPM replace bad socket or wiring
Light is bright but reflector turns Bearing oiled by user Thoroughly clean and don't re-oil
slow - less than 70 RPM Dirty or defective gears or bearings Clean or return to P.S.E.
Noisy operation Gears not worn in Let run for 1-2 hours, some noise
is normal
Blows fuses Defective cigarette lighter socket Try in another vehicle
Replaced lamp with wrong type Use only 55 watt H-1 lamps
Damaged cord or wiring in Dash- Repair or return to P.S.E.
Laser ®
Reversed polarity on a permanent See Permanent mounting section
installation.
Adhesive mounting will not stick to (see " Interior Mounting" section Use new adhesive pad
the surface on page 4)
Dome screw will not snug up Stripped or cracked screw boss Replace screw with #6x1/2" sheet
metal screw or replace dome
Magnet does not hold well Debris Clean magnet
Wax Remove excess wax
Uneven surfaces Use permanent mount
11