beautypg.com

Mounting instructions for nfpa compliance – Code 3 Arch Beacon User Manual

Page 7

background image

7

Mounting Instructions for NFPA Compliance:

When the beacon's lens is removed for installation, the warning signal producing optic-LED assemblies can

be identified by inspecting the label on the beacon base or noting the silver stars on the controller board.

Multiple beacons may be mounted at the corners of a vehicle as shown below. Some special service

beacons are built where the warning signal is limited to half the circumference of the beacon. These beacons

must be arranged so the warning signal faces at 45° to the longitudinal axis of the vehicle in order to comply

with NFPA standards.