Code 3 Arch Beacon - Manual (Page 2)

2
Features and Specifications:
Operating Voltage: DC11V-16V, Reverse Polarity Protected
Operating Current: Avg 3.75 amps, Max 7.5 amps
Weight: 4.5 lb
Flash Modes Description:
1. Cycle-Flash: Cycles through Quad, Double, Triple, and Single modes.
2. Quad-Flash: Four consecutive pulses per flash.
3. Triple-Flash: Three consecutive pulses per flash.
4. Double-Flash: Two consecutive pulses per flash.
5. Single-Flash: Single pulse per flash.
6. Variable Single-Flash Single pulse per flash with varying flash rate.
Please note that a beacon set with a PHASE 0 flash pattern will alternate with beacons set with a PHASE 1 pattern
and flash simultaneously with beacons set with a PHASE 0 flash pattern.
Introduction
The ARCH ™ Beacon is a weatherproof LED based warning light that contains 36 state-of-the-art high intensity
LEDs in three stacked rows. The unique design efficiently captures light from the LEDs with individual optics
that diffuse the light in an effective warning pattern.
This Product contains high intensity LED devices. To prevent eye damage, DO NOT stare
into light beam at close range.
WARNINg!
The use of this or any warning device does not insure that all drivers can or will observe or react to an emergency
warning signal. Never take the right-of-way for granted. It is your responsibility to be sure you can proceed
safely before entering an intersection, driving against traffic, responding at a high rate of speed, or walking on
or around traffic lanes.
The effectiveness of this warning device is highly dependent upon correct mounting and wiring. Read and follow
the manufacturer’s instructions before installing or using this device. The vehicle operator should insure daily that
all features of the device operate correctly. In use, the vehicle operator should insure the projection of the warning
signal is not blocked by vehicle components (i.e.: open trunks or compartment doors), people, vehicles, or other
obstructions. This equipment is intended for use by authorized personnel only. It is the user’s responsibility to
understand and obey all laws regarding emergency warning devices. The user should check all applicable city,
state and federal laws and regulations.
Code 3 , Inc., assumes no liability for any loss resulting from the use of this warning device.
Proper installation is vital to the performance of this warning device and the safe operation of the emergency
vehicle. It is important to recognize that the operator of the emergency vehicle is under psychological and physi-
ological stress caused by the emergency situation. The warning device should be installed in such a manner as
to: A) Not reduce the output performance of the system, B) Place the controls within convenient reach of the
operator so that he can operate the system without losing eye contact with the roadway.
Emergency warning devices often require high electrical voltages and/or currents. Properly protect and use cau-
tion around live electrical connections. Grounding or shorting of electrical connections can cause high current
arcing, which can cause personal injury and/or severe vehicle damage, including fire.
PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER USE OF EMERGENCY
WARNING DEVICES IS ESSENTIAL TO INSURE THE SAFETY OF EMERGENCY PERSONNEL AND THE
PUBLIC.
WARNINg!