Code 3 Arch Beacon - Manual (Page 6)

6
Optional 1in NPT
Pipe Mount Assembly:
1. Remove beacon outer lens.
2. Choose the 6" dia hole pattern. Identify the 3 holes
chosen as indicated on the base's label and punch out
with a sharp object.
3. Align the base gasket and and perimeter of the bea-
con base and punch out the 3 chosen mounting holes
with a sharp object. Place base gasket, adapter plate,
pipe mount gasket, and pipe mount flange against base
of beacon assembly.
4. Install three machine screws #10-24x1.5, flat wash-
ers with neoprene backing, and lock nuts (included) as
shown to attach gasket and pipe mounting
plate to beacon base.
5. Reinstall beacon outer lens.
6. Caution: do not thread pipe past depth of threads
Optional Branch
guard Assembly:
1. Remove beacon outer lens.
2. Choose the 6" dia hole pattern. Identify the 3 holes
chosen as indicated on the base's label and punch out
with a sharp object.
3. Use the branch guard base to locate holes on
mounting surface. Holes should accomodate a #10
fastener. A hole should be provided for wiring access
at the center of the mounting area. The hole should be
grommeted and sealed with RTV around the wiring.
4. Align the base gaskets and and perimeter of the
beacon base and punch out the 3 chosen mounting
holes with a sharp object. Place base gasket, branch
guard base, second base gasket, and beacon as-
sembly on mounting surface being careful to align the
mounting holes. Care should be taken to not pinch the
wiring when placing the beacon assembly.
5. Install three #10 fasteners, flat washers with neo-
prene backing, and lock nuts (included) as shown to
attach the assembly. Apply RTV to the fastener holes
during the installation.