BoonDocker YAMAHA: Phazer User Manual
Page 12
BoonDocker – 1585 Hollipark Dr. Idaho Falls, ID 83401 – 208-542-4411 / 877-522-7805
www.boondockers.com – email:
– fax: 208-524-7381
Revised 05-07-07
Page 12 of 16
6. Button (ARM) and TPS: The nitrous button input on the Control Box can be used to quickly arm and disarm
nitrous capability. When armed (button input is on), the system can be configured to activate with TPS.
Optionally, the handlebar button, which is momentary (only activated while pressed), can be replaced with a
toggle, rocker, or slide switch so it remains in the on or off position (when not pressed).
7. Button (ARM) and TPS and RPM: Same as option 6 above except with RPM capability. When armed (button
input is on), the system can be configured to activate with TPS and RPM.
B. N2O Configuration Procedure
Note: All nitrous configuration settings are stored in the same map as the EFI settings. All changes you make become
part of the current map. The current map number is shown in the Main Menu.
From the Main Menu, select the N2O option. Below is a description of this menu:
Fuel TPS RPM Btn
Æ
040 OFF OFF OFF
Fuel 040
Fuel setting during nitrous activation
TPS OFF
Shows TPS mode is OFF or displays TPS trigger value
RPM OFF
Shows whether RPM mode is ON or OFF
Btn OFF
Displays button mode (described in detail below)
Fuel:
The nitrous fuel adjustment tuning procedure is described above in section VIII.
N2O Fuel Delay
Æ
050 000
Descritpion of N2O Fuel menu for NON / FIX mode:
050
N2O fuel setting. Amount is centered at 1000psi, if bottle pressure is lower, actual fuel
delivered will be reduced, if bottle pressure is higher, actual fuel delivered will be higher.
Delay 000
Delay in number of engine cycles from when nitrous is activated to when fuel is delivered.
Use this feature to reduce any bog that occurs due to fuel being delivered before nitrous
arrives in the engine.
TPS:
To select throttle-position triggering, move the cursor until it is under TPS and press “SEL”, Up or Down
Arrow. The following screen will appear:
TPS N2O on if
Æ
OFF TPS > 200
TPS OFF
Shows TPS mode is OFF.
200
TPS threshold value.
Under
TPS, press the Up or Down Arrow to toggle the TPS mode ON or OFF.
Move the cursor right to the 200 setting, then use the Up and Down Arrows to select the trigger level. This
number is set to near 200 at the factory. You can adjust it from 50 to 248.
Press the “SEL” button to return to the Main Menu.
RPM:
To select rpm triggering, move the cursor right until it is under RPM and press “SEL”, Up or Down Arrow.
The following screen will appear:
.
RPM Min Max
OFF← 5050 7550