BoonDocker POLARIS: 2011-14 PRO RMK 800 Intercooled - Manual (Page 6)

Revised 10/22/2014 Page 6 of ?
www.boondockers.com………………..... ……….………………....877-522-7805
25. Install foot rest kick plate. ( Note: install kick
plate “only install the 2 lower rivets on top running
board at this time”) the last rivet will be installed
later to adjust clearance
26. Remove the stock pipe from Y-pipe, remove
the exhaust donut and run a bead of silicone
around inside and reinstall on Y-pipe,
Note:
make sure to align notches on Y-pipe to donut
27.Run a bead of silicone on the inside of the
flange on the exhaust pipe. 28. Install springs from pipe to Y-pipe 2-springs
on side spring tabs and 3-springs on top spring
tab.
29.Run a bead of silicone on inside of the small
exhaust donut and install on pipe 30. Run a bead of silicone on inside of the bell
of turbo inlet pipe. Bolt inlet to turbo using 4
bolts and 4 hole gasket . If installing stainless
Tial see next step.