Salter Brecknell 7820B - Manual (Page 10)

10 7820 B UPS Revenue Recovery Scale User’s Manual
Enabling/Disabling Weight
Hold Setting
There are four modes available to you. They are as follows:
DIAG (Diagnostic Mode) – To test areas of the scale’s function
CONF (Configuration Mode) – To configure the scale for your application
CAL (Calibration Mode) – To calibrate the scale
DISP (Backlight Display Mode) – To change backlight setting
Follow these steps to enable/disable the Weight Hold function in the CONF
menu. Refer to the menu structure in Figure 5.
1. From normal weighing mode, move Switch 1 to the MENU Mode or
OPEN position. (See Figure 4).
DIAG is displayed.
2. Press the ZERO key. . .
CONF is displayed. This stands for configuration.
3. Press the HOLD key. . .
FILTER is displayed.
4. Press the ZERO key twice. . .
SEAL is displayed. This stands for the Weights and Measures
sealing method.
5. Press the HOLD key. . .
NSEAL is displayed. This stands for non-sealed.
6. Press the ZERO key. . .
SEALD is displayed. This stands for sealed.
7. Press the HOLD key to accept. . .
Close Switch 1 to return to normal weighing mode.
Figure 5
Mode menu structure