Salter Brecknell B140 - Manual (Page 13)

B140 Counting Scale User Instructions 13
2.2.2 Key Functions
Each of the keys shown in Figure 2.5 is explained below.
Figure 2.5 B140 Keypad
0-9 Use for keyboard entry of piece weight, sample size, and upper
and lower limit settings.
PLU1-PLU8 In Counting mode use these keys to recall a piece weight from
memory PLU1 through PLU8.
PT1/PT2 In Counting mode, use these keys to recall a preset tare from PT1
or PT2.
Hi/Lo In Counting mode, use this key to set an upper (higher) or lower
limit quantity for the count check feature.
Clear In Counting mode, use this to erase a keyed in value from the
display while inputting data.While displaying accumulation data,
this key will clear the accumulator memory to 0.
Pwt In Counting mode, use this key to enter a piece weight (by numeric
entry from keyboard or sample a known quantity of items to get
piece weight).
Enter Use to confirm or save entered data from keyboard or confirm the
operation.
Disp Total Use to display accumulation of piece counts in Counting mode or
display accumulation of value of one kind of coin or one kind of
currency in Coin Counting mode.
Add Total Use to add the displayed counts to a piece count accumulator
(Memory +) in Counting mode.
Print Use to send data to the RS232 port, if it installed
Unit In Counting mode, use to switch displayed weights or piece weight
between kg and lb.
Zero Set a new zero point. Zero range capability is ±2% of scale
capacity.
PLU1 PLU3 PLU4 PLU2
PLU5 PLU7 PLU8 PLU6