Salter Brecknell CB100 - Manual (Page 7)

2. Press the PCS key to increment the number. When the timer setting
you want is displayed, press the TARE key…
The value stops flashing and the value is stored in memory.
3. Press the ON/OFF key…
The scale restarts and returns to normal weighing mode.
1.5 Error Messages
Following are error messages which may be displayed, their
cause and solutions.
Display Problem Solution
A.ch.Er Analog error Recalibrate the scale
0¯ Problem with calibration Recalibrate the scale
¯ Problem with calibration Recalibrate the scale
_ Problem with calibration Recalibrate the scale
0¯ ¯ ¯ ¯ Zero point is too large Rezero or recalibrate the scale
EEP.Er EPROM error Contact your dealer
- - - - - Weight is over 100.09g Remove some of the weight
_ _ _ _ _ Input signal is too small Rezero or recalibrate
PC.Er Unit weight is less than 1 division Add weight