Salter Brecknell CB100 - Manual (Page 4)

5. Press the ON/OFF key to power up the scale…
After a self-test, the scale will display weight in the current unit of
measure. The scale is ready to weigh. See the note below
before continuing. A blinking unit of measure label means the
weight is not stable. If CAL-? appears on the screen and ? is
flashing, recalibrate the scale. See the Calibration section.
6. Press the UNIT key to change the unit of measure. The unit icon
appears above the weight display. Choices are: g (grams), gn (grain),
ozt (troy ounces), oz (ounce), dwt (pennyweight), and ct (carat).
7. Press the TARE key to zero the scale. The scale has a zero-tracking
function. The minimum weighing value is 0.01g. Values below this are
automatically zeroed.
8. To power down the scale press the ON/OFF key.
1.2.1 Weighing
1. Power up the CB100.
2. Press the TARE key to zero the scale, if necessary.
3. Place the item to be weighed on the weighing platform. DO NOT
EXCEED THE CAPACITY OF THE SCALE.
The weight is displayed in the chosen unit of measure.
4. Remove the item form the weighing platform.
5. Repeat steps 2 - 4 .
IMPORTANT: Allow 2 to 3 minutes for the scale electronics
to warm up before proceeding otherwise inaccuracies may
occur.