Salter Brecknell CB100 - Manual (Page 3)

1.2 Complete Weighing Instructions
1. Remove the battery compartment door from the bottom of the scale and
attach and insert a 9v battery and replace the door. Or, plug the power
adapter into an appropriate outlet and plug the connector into the
receptacle on the left rear corner of the CB100.
2. Gently place the weighing pan in the receiver hole.
3. Use the bubble level and screw out feet to level the scale. Place the
scale on a stable, flat surface free of drafts.
4. Turn the transport locking screw counter-clockwise 4-5 full turns
before weighing. To prevent damage to the loadcell when moving the
scale, turn this locking screw clockwise until snug. See illustration
below.
CAUTION: To prevent damage to the scale, do not
physically press on the platform or exceed the rated
capacity of the scale.
Weighing pan
Transport locking screw
Bubble level
Adjustable screw feet