Coleman 16'X13' - Manual (Page 2)

3 Raise Screen Room
–Assemble all chain shock-corded
Roof Pole. When assembled will
form a continuous arch with both
ends pointing down. (illus. 6)
–Insert square end of upright poles into
curved roof poles and raise tent upright.
(illus. 7 & 8)
–Angle screen room upright pole back
toward tent body and insert pin of
pin & ring system into end of pole.
–Repeat for second pole. (illus 7)
Pin inserted into
screen room upright pole
4
illus. 8
Curved ridge pole
attaches to
upright pole
illus. 7
Tent shown
without rainfly
illus. 11 Tent shown completed.
Attach Rainfly
–Assemble rainfly pole by interlocking
shock-corded pole.
–Insert rainfly pole into reinforced pockets
located at the center edges of the
underside of rainfly. (illus. 9 & 10)
–Tie underside of rainfly to the rainfly
pole with pole ties. (illus. 9)
–Drape rainfly over tent frame, pole side
down. Rainfly pole should point out over
screen room and rear window of tent.
–Connect the eight elastic loops with
“S” hooks, (found at the rainfly corners)
to the eight rings located at the end of
the stake loops at the corners of the tent.
–Secure rainfly with frame ties
located on underside of rainfly. (illus. 11)
–Stake out tent with four side
guylines. (illus. 11)
Brace Pole
Curved
poles in
pole sleeve
Underside frame
ties attach to tent
poles
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
PRINTED IN SRI LANKA
Rev. 11/00
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent.
Condensation is caused by water vapor from your breath, perspira-
tion, or any wet clothing inside your tent. It is NOT LEAKAGE
through the tent fabric. It can be minimized by removing wet clothing
from your tent and by providing good ventilation through the tent.
•
Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE
ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE
LOOP TO REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•
Seam sealer has not been provided with your tent. It is necessary
and we recommend seam sealing your tent prior to camping. Seam
sealer may be purchased through your local retailer or at your
local sporting goods store.
•
Do not leave your tent set-up for weeks at a time, be aware that
exposure to the ultraviolet rays of the sun can seriously damage
nylon material and/or cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flamma-
bility requirements of CPAI-84.The fabric will burn left in continuous
contact with any flame source.The application of any foreign substance
to the tent fabric may render the flame-resistant properties ineffective.
Illus. 6 Curved Roof
Pole assembly.
Screen ridge pole sleeve
Forms an arch
illus. 9 Insert
Rainfly Pole
piece into
pocket on
underside of
Rainfly
Frame ties
Pole ties
illus. 10
Underside of rainfly
shown with pole inserted
into pole pockets
Guylines