Coleman Kraz X1 - Manual

Connect Frame to Tent
– Insert one Pole Talon™ into pole on stake loop
located at middle edges of the tent.(illus. 3)
– Go to opposite end of pole and
gradually apply pressure to the
pole forming an arch until you
are able to insert the pole talon
into the pole.(illus. 3 & 4)
– Attach Frame Clip on each
side of tent. (illus. 5)
– Tie frame ties
around the tent pole.
Kraz
™
X 1
part number 2000000451
1
2
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with doors facing
desired direction. (illus. 1)
– For best results in windy conditions position
end of tent into the wind.
– Stake down tent corners using the stake loops.
Keep the floor taut. Unzip doors. (illus. 2)
– Assemble Frame Poles by interlocking
shock-corded sections. This will make one long
and one short “U” shaped pole.
– Insert the longer pole through the pole sleeve
located in the middle of the tent and the shorter
pole into the sleeve at the foot of the tent. (illus. 1)
Main Tent Pole
Part No. 9830-1191
Foot Pole
Part No. 9830-1291
Rainfly
Part No. 9830-1391
illus. 1
Two side doors
Pole Sleeve
illus. 2
Tent stake
through Loop
illus.3
Insert Pole Tip
into grommet
illus.4
Tent completely set up and
staked out.
POLE ASSEMBLY PART
illus. 5
Frame Clips