AVer P5000 series - Manual (Page 109)

100
4. The No., Name, Description, and Priority column display the current alarm ’s information.
The Trigger Type displays the current alarm
’s trigger condition.
5. In Alarm Reset section, click the camera number to set the reset condition of alarm. Once
alarm is reset, all alarm action will stop at the moment. If the sensor normal status is high,
set the alarm reset condition to low.
IP Camera Sensor: To adjust sensor high/low that is connected on the IP camera.
- Alarm Reset Time: Set a time for the alarm auto reset. When an alarm happen such
as motion detected and video loss, the alarm will reset at the alarm reset time.
6. In Action section, user may now set the alarm action for the system to perform when the
alarm condition is activated.
- Launch E-Map: Display mini E-map on the screen.
-
Enlarge Camera View
Switch to only display video in Preview mode from where the alarm is activated.
a. Select the camera from drop down list to specify which camera video to be
enlarged on screen when the alarm is triggered.
b. Retrieve time: set the waiting duration before system switching back to original
Preview mode. If the retrieve time is un-set, the alarm video will keep enlarging
until user switch back to Preview mode manually. The retrieve time range is 0~ 300
seconds.