LG F1492QD1 - Manual (Page 91)

roubleshooting guide
Symptom Possible Cause Solution
> Water supply is not adequate in area.
> Water supply taps are not completely
open.
> Water Inlet hose(s) are kinked.
Check another tap In the house.
Fully open tap.
Straighten hose(s).
Check the filter of the Inlet hose.
> The filter of the inlet hose(s) are clogged.
I
> Drain hose is kinked or clogged.
> The drain filter Is clogged
Clean and straighten the drain hose.
Clean the drain filter.
• Load Is too small.
>
Load Is out of balance.
> The appliance has an Imbalance detection
and correction system. If Individual heavy
articles are loaded (ex. bath mat, bath robe,
etc.) this system may stop spinning or even
interrupt the spin cycle altogether.
> If the laundry Is still too wet at the end of the
cycle, add smaller articles of laundry to
balance the load and repeat the spin cycle.
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning
Ulose tne door.
* If “ dE ” is not released, call for
service.
' Is the door opened?
Unplug the power plug and call for
service.
' Water overfills due to the faulty water valve.
Close the water tap.
Unplug the power plug.
Call for service.
> Water level sensor has malfunctioned.
' Over load in motor.
' Over load in motor.
> The washer experienced a power failure. Restart the cycle.