LG F1492QD1 - Manual (Page 69)

nstallation
■ Electrical connection
1. Do not use an extension cord or double adapter.
2. If the supply cord is damaged, It must be replaced by the manufacturer or Its service agents or similarly
qualified person In order to avoid a hazard.
3. Always unplug the machine and turn off the water supply after use.
4. Connect the machine to an earthed socket In accordance with current wiring regulations.
5. The appliance must be positioned so that the plug is easily accessible.
• Repairs to the washing machine must only be carried out by qualified personnel. Repairs carried out by
Inexperienced persons may cause Injury or serious malfunctioning. Contact your local service center
• Do not Install your washing machine in rooms where temperature below freezing may occur. Frozen hoses may burst
under pressure. The reliability of the electronic control unit may be Impaired at temperatures below freezing point.
• If the appliance is delivered In the winter months and temperatures are below freezing: Place the washing
machine at room temperature for a few hours before putting It into operation.
The appliance Is not Intended for use by young children or Infirm persons without supervision.
Young children should be supervised to ensure that they do not play with appliance.
* •
CAUTION concerning the Power cord
Most appliances recommend they be placed upon a dedicated circuit; that is, a single outlet circuit which
powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this
owner's manual to be certain. Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall
outlets, extension cords, frayed power cords, or damaged or cracked wire insulation are dangerous.
Any of these conditions could result in electric shock or fire. Periodically examine the cord ofyour appliance, and
if its appearance indicates damage or deterioration, unplug it, discontinue use of the appliance, and have the
cord replaced with an exact replacement part by an authorized servicer. Protect the power cord from physical or
mechanical abuse, such as being twisted, kinked, pinched, closed in a door, or walked upon. Pay particular
attention to plugs, wall outlets, and the point where the cord exits the appliance.
If the appliance is supplied from a cord extension set or an electrical portable outlet device, the cord extension
set on electrical portable outlet device must be positioned so that it is not subject to splashing or ingress of
moisture.
■ Washing Machine is to be connected to the water mains using new hose-sets and old hose-sets
shonld not be nsed.
■ Connecting water supply hose
I
► Water supply pressure must be between 30kPa and lOOOkPa
(0.3~10kgflcnf)
Don't strip or crossthread when connecting Inlet hose to the valve.
If the water supply pressure is more than lOOOkPa, a decompression device
should be installed.
• Two rubber seals are supplied with the water inlet hoses. They are
used for preventing water leaks.
• Make sure the connection to taps is tight enough.
• Periodically check the condition of the hose and replace the hose if
necessary.
• Make sure that there Is no kink on the hose and that It Is not crushed.
After completing connection, If water leaks from the hose, repeat the same steps. Use the most conventional type
of faucet for water supply. In case the faucet Is square or too big, remove the spacing ring before inserting the
faucet into the adaptor.
y