Installation place requirement, Level floor, Power outlet – LG F1492QD1 User Manual
Page 68: Additional clearance, Bs plug safety details (for u.k. user), Important, Nstallation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
nstallation
Installation place requirement
Level floor:
Allowable slope under entire washer is 1 °
Power outlet:
Must be within 1.5 meters of either side of location of
washer. Do not overload the outlet with more than one
appliance.
Additional Clearance:
For wall, door and floor modeling is required.
(10cm : rear/2cm:right & left side)
Do not place or store laundry products on top of washer at
any times.
They can damage the finish or controls.
Install the washer on a flat hard floor.
Make sure that air circulation around the washer is not impeded by carpets,rug etc.
• Never try to correct any unevenness in the floor with pieces of wood, cardboard or similar materials
under the washer.
• If it is impossibie to avoid positioning the washer next to a gas cooker or coai burning stove,an
insuiating(85x60cm) covered with aluminum foii on the side facing the cooker or stove,must be
inserted between the two appiiance.
• The washer must not be instalied in rooms where the temperature can drop beiow 0°C.
• Piease ensure that when the washer is instaiied, it is easiiy accessibie for the engineer in the event of
a breakdown.
• With the washer installed adjust all four feet using the transit bolt spanner provided ensuring the
appiiance is stabie, and a ciearance of approximateiy 20mm is ieft between the top of the washer and
the underside of the work-top.
BS Plug Safety Details (For U.K. User)
IMPORTANT
THE WIRES IN THIS MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:
GREEN AND YELLOW: EARTH
BLUE:NEUTRAL
BROWN: LIVE
This appiiance must be earthed
As the coiours of the wires in the mains iead of this apparatus may not correspond with the coioured markings identifying
the terminate in your piug, proceed as foliows:
The wire which is coioured Green and Yeiiow must be connected to the terminai in the piug which is marked with the tetter E
or by the earth symbol @ or coioured Green or Green and Yeiiow.
The wire which is coioured Biue must be connected to the terminai which is marked with the letter
N
or coloured Black.
The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red.
If a 13 amp (BS 1363) plug is used, fit a 13 amp BS 1362 fuse.