Canon T2000 - Manual (Page 54)

Changing the lamp
1. Remove front cover.
2. Caution: Wait until the
lamp has cooled down
sufficiently to avoid burns!
3. Turn framing knob (3)
fully counterclockwise.
4. Press down on lamp­
holder spring (25) and
swing it out to the left.
5. Withdraw lamp socket,
grasp dichroic reflector at
its front and remove lamp
with reflector by pulling
forward.
6. Plug a new 12 v, 100 w
tungsten-halogen lamp
with dichroic reflector
(supplied by Osram,
Philips, Atlas and Sylva-
nia) into the lamp socket.
Caution: Never touch in­
side of reflector or quartz
bulb of lamp with your
bare fingers! Fingerprints
would burn into the glass
and impair illumination.
7. Hold lamp socket with
its two leads facing for­
ward and fit lamp reflector
into projections of mount­
ing plate.
8. Hold lamp with socket
in this position and swing
in lampholder spring (25),
fitting it under the projec­
tion at the forward end of
the mounting plate.