Canon ZOOM76 - Manual (Page 34)

Troubleshooting
ln case of problems, check the table below before
taking your camera to be repaired.
Problem Cause Remedy Page
The Q icon •The battery has run • Replace the battery 13
blinks on the
LCD panel out of charge
The ll icon is • No battery is loaded • Install the battery 13
not displayed • The battery is installed •Reinsert the battery 13
on the LCD with the wrong polarities correctly
panel •The battery has
completely run out of
charge
•Replace the battery 13
The shutter •The mode dial is set to •Set the mode dial to 24
does nol cm the appropriate setting
release •The battery has run •Replace the battery 13
out ol charge
•The lilm is not loaded •Load a new film 14
correctly.
•Arewound (used) film •Remove the film and 23
has been loaded load a new one
•The shutter releases •Hold the shutter button 27
only after the red-eye down until the shutter
reduction lamp is lit for releases
about 1 second •Change the flash
mode to ffjiiw
25
The •When the shutter •Ensure that the AF 12
photographs are was released, the emitter/sensor are
blurred AF emitter/sensor not blocked by hair,
were blocked fingers, etc
•In 0 mode, you •Make sure you do 30
were standing not stand
directly in front of immediately in front
the camera when of the camera when
you pressed the pressing the shutter
shutter button button
•The camera moved •Press the shutter 19
when the shutter button slowly and
button was pressed
(camera shake) gently
•The AF emitter/ •Wipe them clean 12
sensor or tens is
dirty
0-36