Loading and removing the film, Loading the film, Open the back cover and load the film – Canon Sure Shot 115U User Manual
Page 6: Pull the film out to the ».ihbl, Film leader position indicator), Close the back cover, Removing the film
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Loading and Removing the Film
■ Loading the Film
^ Open the back cover and load the
film.
• Push the back cover release lever
down.
Position the film correctly
between the film guides.
Pull the film out to the ».iHbl
niM
(film leader position indicator).
• Make sure that there is no slack in the
film when you pull It out.
• If the edge of the film leader goes
beyond the film leader position
indicator, rewind some of the film back
into the cartridge.
Close the back cover.
■♦The film automatically winds on to the
first frame and “1" appears on the
frame counter.
• If the frame counter shows a blinking
“0”, the film did not load correctly. Load
the film again.
3
ISO 400 DX-coded film is recommended.
■ Removing the Film
The film rewinds automatically when it
reaches the end.
When the film is fully rewound, the frame
counter shows “0" and the ^ blinks. Then
open the back cover and remove the film.
• If the
©
is not blinking, press the button
O The date and time may not be imprinted on the last frame if you take
more pictures than stipulated on the film.