Canon P 400 - Manual (Page 10)

Setting of Voltage
Before using Canon Cine Projector P-400, be sure to set
the voltage sw tch at the voltage to be used. The fuse
\A/ill blow out or the motor will not function if the voltage
is not properly set.
To change the voltage, turn the voltage switch inside the
voltage indicator window with a screwdriver until the
desired figure appears.
Preparations for Projection
1 When loading the film check the end of the film. In
* case the film is bent or any foreign substance is no­
ticed on the f Im, cut this section with the film cutter
separately supplied.
O Set the film selector. Press down the lever of the film
^ selector so that it shows "S” matching the red dot in
front when projecting Super 8 or Single 8 film. In case
of regular 8mm film, pull up the lever to show "R” instead.