Canon EOS 1N RS - Manual (Page 14)

1. Loading the Battery
This camera operates on a 6-volt, 2CR5 lithium battery, housed in the
grip.
• Refer to page 93 for additional information on the batteries of the EOS-1 N DP
model and page 96 for the EOS-1 N HS model and the EOS-1 N RS model.
^ Using a coin or similar object, turn
the grip screw counterclockwise to
loosen the grip. The screw cannot
be removed from the grip.
P Slide the grip down to remove.
3 Load the battery upside down into
the grip so that its terminals align
with the terminals in the battery
compartment.
• The battery label should be facing
toward you and the terminals should
be on the bottom after the battery is
installed.
After placing the battery into the
front of the compartment, push it all
the way into the compartment as
shown in the illustration.
• To remove the battery from the grip,
press the battery ejector lever.
5 Replace the grip on the camera and
turn the screw clockwise to firmly
lock it in place.
Lithium batteries may not be available in some areas. Be sure to take along a spare when
going on a trip or embarking on an important shooting assignment.
14