Canon A2 - Manual (Page 17)

Specifications
Winding Speed: Approximately 0.5 seconds
Operation: When the shutter button on the camera is pressed, the
winder will function
Shutter Speed Coupling Range: 1/60 to 1/1000 second for con­
tinuous photography. “B," or any shutter speed of each camera for
single frame photography. (However, if set at "B," AE photography
cannot be performed.)
Shooting Modes: Controlled by main switch when the Power
Winder A2 Is mounted on A-1 or AE-1 PROGRAM.
Two Positions: "C" for continuous shooting at about two frames
per second (Shutter continuously released and film automatically
wound as long as the shutter button on the camera is pressed .) "S"
for single frame shooting. (Shutter released when the shutter button
is pressed and film automatically wound when the shutter button is
released.)
When the Power Winder A2 is attached to AL-1, AE-1, AV-1 or AT-1:
Continuous shooting possible when you keep the shutter button
pressed down at either "C" or "S" setting Single frame shooting
possible when the finger is removed from the shutter button each
time you press it down once.
Film Counting: Performed by the frame counter on the camera.
Automatic Cut-off Circuit: If winding stops incompletely (such as
when the film roll is completely wound), or If the batteries become
exhausted, the winder will automatically stop and the warning lamp
(LED) will light up
Remote Control: Possible when the winder is mounted on an A-1 or
AE-1 PROGRAM and using Remote Switch 3 or 60, or Wireless
Controller LC-1, or Interval Timer TM-1 Quartz (optional accesso­
ries).
Power Source: Four AA size 1 5V alkaline, carbon-zinc or Ni-Cd
batteries.
Mounting on Camera: By using tripod socket on the camera after
taking off the winder coupler cover on the bottom of the camera
Size: 140.8x27 5X53.4mm (5-9/16" x 1 - 1 / 1 6 " x 2-1/8")
Weight: 275 g (9-11 /16 ozs.) Including batteries.
Subject to change without notice
1 4