Troubleshooting, Problem cause solution – Craftsman 315.220380 User Manual
Page 55
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
Saw does not start.
1. Motor cord or control-cut cord is
not plugged in.
1. Plug in cord.
2. Cord or switch is damaged.
2. Have the cord or switch re
placed at your nearest Sears
Service Center.
3. Circuit fuse is blown.
3. Replace circuit fuse.
4. Circuit breaker is tripped.
4. Reset circuit breaker.
5. Switch is burned out.
5. Have the switch replaced and
request a voltage check from
the power company.
6. Connections are loose, burned
6. Have the wiring checked and
out, or damaged.
repaired. Request voltage check
from power company.
Motor does not reach full speed or
1. Voltage from source is low.
1. Request a voltage check from
power.
the power company.
2. Circuit is overloaded with other
2. Test without any other motors
appliances or motors.
and on different circuit.
3. Motor windings are burned out.
3. Have the windings replaced and
request a voltage check from
the power company.
4. Fuses or circuit breakers are
4. Have an electrician replace with
wrong size.
a 15 amp fuse or circuit breaker.
5. Extension cord is too long.
5. Use a shorter cord.
6. Starter switch is defective.
6. Have the switch replaced.
Motor stalls, blows fuses, or trips
circuit breakers.
1. Starter switch is defective.
1. Have the switch replaced.
2. Voltage from source is low.
2. Request a voltage check from
the power company.
3. Fuses or circuit breakers are
3. Have an electrician replace with
wrong size or defective.
a 15 amp fuse or circuit breaker.
Motor overheats.
1. Motor is overloaded.
1. Request a voltage check from
the power company.
2. Windings are burned out.
2. Have the windings replaced and
request a voltage check from
the power company.
3. Work is being fed too fast.
3. Feed work slower.
55
CRIlFTSMIHr RADIAL SAW 315.220380