Craftsman 315.220380 - Manual (Page 13)

LOOSE PARTS LIST
Check all loose parts from the box with the list below. Use the instructions on the following pages to assemble.
All fasteners are shown actual size.
5. Saw Base To Leg Stand Assembly
A. Saw Assembly (not shown).............................1
B. Leg Stand Assembly (not shown).................. 1
C. Hex bolt (5/16-18 X 5/8 in. Hex Head)............. 4
D. Washer (5/16 in.).............................................. 8
E. Lock washer (5/16 in.)......................................4
F. Hex Nut (5/16-18)..............................................4
6 .
(o) @ ©
Hardware for Front Table
A. Front table....................................................... 1
B. Screw (1/4-20 x 1 in.)..................................... 4
C. Washer (1/4 in.)................................................4
D. Lock washer (1/4 in.)...................................... 4
E. Hex nut (1/4-20)............................................... 4
^mmm
@ (Q) ©
B
7. Rear Table.................................................................1
9. Fence.
10. Leveling Hardware for Front Table
A. Screw (1/4-20 x 1-3/4 in.)............
B. Washer.........................................
C. U-clip...........................................
D. Setscrew......................................
E. Tee nut.........................................
11. Scale Indicator
A. Screw............................................................... 4
B. Speed Nut........................................................ 2
C. Indicator.......................................................... 2
D. Switch Key.......................................................2
inroTF
B
Fig. 6B
CRRFTSMRN*
RADIAL SAW 315.220380