Operation, Non-through cuts – Craftsman 315.220380 User Manual

Page 53

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATION

NON-THROUGH CUTS

See Figure 49.

VV WARNING:

Unplug the saw while removing or

replacing the blade guard. Turn on the saw with

the switch on the arm to confirm the blade is not

receiving power.

■ Remove the blade and blade guard (see

Assembly

section).

■ Place a support the same height as the saw table

nearby for the cut work. Lower the blade with the
elevating handwheel.

■ Make sure the wood is not touching the blade.

Insert the key and turn on the saw. Let the blade

build up to full speed before contacting the work
piece.

WARNING:

Always use pushblocks when

making non-through rip cuts to avoid the risk of
serious injury. Never feed wood with your hands.

■ When the work is completed, press the switch off

and remove the key.

NON-THROUGH CUT

Fig. 49

MRFTSMflir RADIAL SAW 315.220380